Once the trunk is open you need to remove the lock mechanism.
My door panel on my 06 impala co ing off.
It is held on by two bolts.
I open the door then it turns off.
Pry off the door reflector with a flat blade screwdriver.
In this video 1a auto shows you how to remove or replace the interior door panel trim on your vehicle.
In the trunk on the trunk lid is an emergency release handle.
On the inside trim you can remove screws that are by the door handle arm rest under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don t want to break them.
Pull off top edge door panel.
If you own this vehicle you know that there is no manual keyhole on the trunk.
Remove the 8mm bolt behind the reflector.
My 06 impala tunk would not open using my key fob or the trunk button on my car.
When i turn the car off the radio is suppose to stay on until.
You ll need to lift the door panel upwards in order to get it off the window ledge.
Insert the large flathead screwdriver or the plastic pry bar tool in between the bottom edge of the door panel and the metal door frame.
Remove 2 screws from the door pull handle bracket.
Push in the door panel clips insert the t30 two screws inside the door pull insert the t30 screw inside the door handle insert the 7mm bolt on the back part of the door panel.
I have a 06 chevy impala.
Remove the upper door trim panel from the front door.
Remove the front door trim panel using the trim removal tool in order to disengage the fasteners from the door inner panel.
I have a 2015 impala and noticed when i turn off my car my door buttons radio buttons stay on.
Remove the key but do no open the door.
I had to remove my back seat.
You need to remove the door panel for a number of diff.
Remove the screw from the upper door trim panel.
See if the click you hear is the same as the one you hear when you open the door.
Firmly pull out the bottom edge of the door panel to disengage the plastic pop rivets.
Removing the door panel 0 44 pry off the trim piece inside the door handle with a flat blade screwdriver.
Sit in the car after you shut the engine off.
Plastic pop rivets released.